|
Page 4 of 5
Too short
Now
fit the latches on the side frames, screwing in the actuator rods from
the central unit, and clipping them into the plastic "rowlocks". Test
them by pushing the latch forks down into the locked position. If the
latch won't stay down, then the rod is too short; lengthen it until the
latches will stay down, then (using the threaded adjuster) shorten it
until it pops up again. Back it off half a turn. If both latches "pop"
at the same time when you press the exterior button, then the rods are
evenly adjusted. Finally fit the corner pieces supplied to cover the
lower frame joints with a smear of mastic to keep them in place and
re-attach the frame to the hinges.
|
Fitting 
